‎Sensors | Page 7 | SimpliSafe Support Home
Skip to main content

Conversation List

Filter by

(53)
SA
How To Replace Temperature Sensor Battery

The Temperature Sensor takes a single CR-2032 Lithium 3V battery and has a life expectancy of up to 5 years depending on placement and usage.To change your Temperature Sensor battery, remove it from its bracket to expose the battery compartment. Then replace the battery and slide the sensor back int

Battery / Power

Help Center Article

 • 

Temperature Sensor

SA
How To Replace Water Sensor Battery

The Water Sensor takes a single CR-2032 Lithium 3V battery and has a life expectancy of up to 5 years depending on placement and usage.To change your Water Sensor battery, twist the bottom and top apart and replace the battery inside. To close it again, make sure that the grooves are aligned before

Battery / Power

Help Center Article

 • 

Water Sensor

How to Rename a SimpliSafe® Sensor

There may be a point where you need to rename a sensor for your SimpliSafe® System. Renaming a sensor can be done easily through the SimpliSafe® Mobile App, but you can also rename a sensor using your Keypad. The following will walk you through these steps for each platform so you can pick whichever

Features / Settings

Help Center Article

 • 

Sensors

SA
How To Change The Entry Sensor's Chime Volume

When your system is disarmed and an Entry Sensor is opened, it will relay a chime to the Base Station to notify you of the potential intrusion. This chime is set to medium by default but can be toggled to OFF, LOW, MEDIUM, or HIGH at any time from the SimpliSafeª Mobile App, Web App, or Keypad.Simpl

Features / Settings

Help Center Article

 • 

Entry Sensor

SA
Motion Sensor Gen 1 Settings & Customizations

Your SimpliSafe® Motion Sensor can be customized and tailored to your specific needs. You can enable or disable the sensor from triggering an alarm in Home and Away Mode, turn on Instant Trigger to have the sensor trigger an alarm the moment it is tripped, and change the sensitivity of the sensor to

Features / Settings

Help Center Article

 • 

Motion Sensor Gen 1

SA
Entry Sensor Settings & Customizations

Entry Sensors can be customized for each of the alarm states of your system (Off, Home, and Away). By default, Home and Away are set to Alarm. Off and Instant Trigger are defaulted to Off. If enabled, Instant Trigger results in the alarm instantly sounding when tripped while the system is armed (wit

Features / Settings

Help Center Article

 • 

Entry Sensor

SA
How to Replace Entry Sensor Battery

The Entry Sensor takes a single CR-2032 Lithium 3V battery and has a life expectancy of up to 5 years depending on placement and usage.To change your Entry Sensor battery, slide the sensor up and off its bracket. Then replace the lithium battery and slide the sensor back onto its bracket.If your sen

Battery / Power

Help Center Article

 • 

Entry Sensor