4 Messages
Base Station announce Component or Sensor by name
I know the base station can chime when doors or opened. In fact, in test mode it will announce which alarm is triggered. But is there a way for the basement station to always announce which alarm is triggered (for example, have it say "front door", or "patio door").
Official Solution
davey_d
Community Admin
•
5.7K Messages
1 year ago
Hi folks,
Entry Sensor Announce is available now! Read our post about it here.
0
stephenwolff1
2 Messages
7 years ago
43
davidnkitchen
2 Messages
6 years ago
4
archieblackmon
3 Messages
6 years ago
0
sevensiamesecats
2.2K Messages
6 years ago
0
0
lancerset
3 Messages
6 years ago
Is there a way for the base to say the name of what sensor just activated rather than just beep?
Thanks
1
lance843
1K Messages
6 years ago
9
alexlude23
10 Messages
6 years ago
Would be useful if upstairs to hear "Kitchen" vs "Window" vs "Front Door".
I've heard from Tech Support many others have been asking for this feature as well.
0
jimezzo
2 Messages
5 years ago
For example, if the window in the back of the house was opened, the base station could say "Office Window Open'.
The way it works now(doorbell chime only), has you running around the house looking for the window or door that was opened.
2
susan5656
2 Messages
5 years ago
This might be a deal-breaker for me as it's impossible to hear anything when the room is not quite or if I'm in another room. One of the main reasons for getting this system is to be clearly notified whenever someone opens a door so everyone feels safer at home (especially a multi-floor home) however this system is obviously lacking this feature. Will this be updated anytime soon?
Thank you.
2
holdernevins
4 Messages
4 years ago
thanks,
Holder
32
wilmotdrew
2 Messages
4 years ago
New user and I was super excited to get your system as when I bought it I was told that the base station would chime and also announce which sensor was tripped (i.e. if someone opened the garage door). Unfortunately this isn't the case at there is just a chime that sounds when any sensor is tripped.
After playing around with the system I noticed that in "Test" mode the base station actually announces the sensor name (i.e. Garage Door) which is exactly what I was looking for. From a software perspective it appears you have the attributes available for sensor name, so is there anything on your Road map to have the normal operation utilize the sensor "name" with the chime?
I've seen many hits when I googled this so hoping you can shed some light on this as many folks are asking for it.
Thanks Very Much,
Drew
1
info131
4 Messages
4 years ago
5
barbkrienke
2 Messages
4 years ago
I just set my alarm to home mode for the evening. It activated but told me that one of my sensors was open (I can't remember the exact words). Since all of my sensors have a specific name, it would be much more helpful if I was also notified which specific sensor was not secured. Then I wouldn't have to walk all over the house trying to figure out which one needed closing. Thanks for letting us make suggestions to make SimpliSafe even better! Barb
3
rdeann
2 Messages
3 years ago
The next gen 3 software update needs to include the option of having the open entry point device name mentioned from the base station instead of just a chime. I have four doors and I would like to know which one is being opened. I think it's a lot more safer and it seems like it would be simple.
18