2 Messages
Adjust where grid falls on doorbell camera
I am hoping there is a way to change where the gridlines on my doorbell camera hit so i can record when a car is in my driveway. The grid currently hits where every car or sidewalk walker would record.
is there a way to adjust this? Thanks in advance!
Terry(Simplisafe newbie)
Accepted Solution
captain11
6.6K Messages
@Tcccburkhart short answer, at least for now, is no. Only option is to change the direction the camera is facing by a bit. The grid as it is setup now works well for me, as I can have motion areas just a few feet in from the sidewalk and cover the entire driveway. The camera in the back of the house covers a good size patio and all back doors so the grid is not used at all.
0
0
Tcccburkhart
2 Messages
Captain11,
Thank you. Your reply reminded me that there was a blank mounting wedge to tilt the camera so i tried that. The gridlines seemed to fall in a better place, but somehow it unfortunately seemed to get worse. I guess i need to try tech support again. I have to be doing something wrong. Thanks again.
Terry
0
0
psmcgehee
3 Messages
Why have grid lines if they don’t work? I have done that & set to low motion & people only and it still gets the cars driving by.
0
0