@captain11 That answers one part of the issue not addressed by Emily which was what is the purpose of the micro-usb port. Apparently the micro-usb has no purpose if it is not meant to charge anything. I was curious as to why after sitting in the box since June 2023 (when I bought it) until now I was able to plug it into usb off notebook and the light around button was blinked yellow then white, almost immediately. When I put it on the wired faceplate there was nothing (there was proper voltage on the terminal screws and on the flat copper plates) yet no response on the doorbell. @emily_s did suggest that the micro-usb will not charge the doorbell and it should sit on the faceplate for at least 10 minutes. I put the doorbell back on the faceplate and let it sit for about 30 minutes. When I checked it was blinking white and installed into the system without a hitch. Thank you
Accepted Solution
captain11
6.6K Messages
@andrewd already asked and answered by Davey in another thread....see below.
https://support.simplisafe.com/conversations/cameras/doorbell-micro-usb-port/6190c64f8ea41ebb0620a2c6
2
0