‎davedresselhouse | SimpliSafe Support Home

davedresselhouse

Joined 

November 14th, 2021

About me

No bio added

davedresselhouse's Activities

All Activities
Selected All Activities

davedresselhouse
followed 's post

3 years ago

entry sensor said it was not connected. Replaced the battery now online under device says it is offline.

davedresselhouse
replied to a comment on 's post

3 years ago

entry sensor said it was not connected. Replaced the battery now online under device says it is offline.

@SPO​ I think you're right. I had an entry sensor go offline, and replaced the battery. Device status continued to show the sensor offline, even after I did a manual refresh several times. In test mode, the sensor was found, but continued to display

davedresselhouse
liked 's comment

3 years ago

Not the full story Johnny M. It seems if you take a while replacing the batteries you have to delete then re-add the entry sensor via the add device menu on the keypad... otherwise even with fresh batteries and no obstruction the entry sensor stays

davedresselhouse
joined community.

November 14, 2021

davedresselhouse
replied to a comment on 's post

6 years ago

I recently installed the new Doorbell cam and it works just fine. However, the house I am in must have an old or broken doorbell chime. The wires were in the wall at the door and powered, but I have no idea where the box in the house is and there is no chime (maybe off or broken). Is there a way for

Answering each of your points (1) In terms of timing, how would this be any different from SS sending a doorbell notification to the SS smartphone app (which it currently does)? If you're saying that the delay would be too long to be useful, then th

davedresselhouse
commented on 's post

6 years ago

I recently installed the new Doorbell cam and it works just fine. However, the house I am in must have an old or broken doorbell chime. The wires were in the wall at the door and powered, but I have no idea where the box in the house is and there is no chime (maybe off or broken). Is there a way for

It Could Be Done in Software It seems to me that the requested functionality could be delivered via server software enhancements and a firmware update on the base station. No need for a hardware redesign, the required hardware communication paths