‎co detector | SimpliSafe Support Home
Skip to main content
 
learlg's profile

learlg

1 Message

co detector

CO detector is constantly beeping and yellow fault light is blinking.

Batteries are very good.

Any help is appreciated!

Post

 • 

Updated 

790

1

0

0

This conversation is no longer open for comments or replies and is no longer visible to community members.

Accepted Solution

sevensiamesecats

2.2K Messages

That often means that it is not fully seated on the base.  There is a "tamper switch" on the back of the unit, and a "bump" on the base.  You need to twist it past a "click" to get it fully seated and the tamper switch pushed.

Or it could just be defective.  If fully seating it does not clear the problem, call SS for troubleshooting and replacement if necessary.

0

0

New to the Community? Get started by reading our Welcome Article and please be sure to review our Community Guidelines before posting.

Related Conversations

  • Y

    2

    0

  • Official Response

    2

    0

  • Official Response

    3

    0

  • 1

    0

  • Accepted Solution

    7

Was this post helpful?