This article is about the Original SimpliSafe system. If you purchased a new system in 2018 or later, you likely have the All-New SimpliSafe. If you're not certain which system you have, you can tell the difference here.
Glassbreak Sensors are programmed to listen for the specific frequency of broken glass. They should be installed within twenty feet of the windows you want protected. However, if you have windows with heavy curtains we recommend installing your Glassbreak Sesnors 5-10 feet away from your windows. Glassbreak Sensors are designed to be installed on the wall, however they can be placed on the edge of a flat surface if a corner or wall are not available.
NOTE: You can turn down the sensitivity of the Glassbreak Sensor via the switch on the back of the sensor. Simply slide the Glassbreak Sensor off its bracket, and you will expose a small black switch. Slide it towards the "L" to lower the sensitivity.
To install your Glassbreak Sensor remove the white battery activation strip hanging out of the battery compartment. Next, remove the liner from the adhesive strip attached to the Glassbreak Sensor’s bracket, and adhere the Glassbreak Sensor to the surface in the location you want it to be installed. Make sure that your Glassbreak Sensor is facing the windows you want it to secure. Press and hold the Glassbreak Sensor for 30 seconds to ensure it is firmly attached to the wall. If you would prefer your Glassbreak Sensor to be permanently attached to the wall, slide it up off of it’s bracket, and you can use the included screws to attach the bracket to the surface. After, slide your Glassbreak Sensor back on to the bracket, and it is installed.
If you are installing a new Glassbreak Sensor to an existing system it can be added through your Keypad, or the Easy Setup Wizard. View this page for additional information.
Our support team will be happy to help if you experience any issues during installation. We are open 7 days a week from 9:00 AM - 12:00 AM EST.