Does your Keypad look like the one pictured to the left? Then you're in the right place! You've got the All-New SimpliSafe system. If you purchased a system in 2017 or earlier, you have the Original SimpliSafe. Click here to view the article about the Original SimpliSafe. If you're not certain which system you have, you can tell the difference here.
Your SimpliSafe system has a built-in Test Mode to let you test all of your sensors.
From the keypad, go to the “Menu” and select “Test Mode”. Follow the instructions below for each sensor that you’d like to test. The Base Station will announce the sensor type to confirm that it has received the signal. If you have a professional monitoring plan, you will receive a phone call confirming the test.
Sensor Testing Instructions (while in Test Mode):
Press the Test Button on the top of the Motion Sensor. For an accurate test, leave the room for the sensor you are testing then wait 15 seconds. Re-enter the room and the Base Station will say “Motion Sensor.”
Press Test Button on the top of the sensor then clap your hands loudly near your windows. Glassbreak sensors will respond to any loud sound in Test Mode (whereas normally they only respond to breaking glass).
Open and close protected doors and windows.
Hold the Panic Button down for 2 seconds.
Smoke and CO Detectors:
Hold the Test Button on the front of the sensor for 4 seconds. The sensor will beep 3-4 times.
Extra Siren, Water, and Temperature/Freeze Sensors:
Press the Test Button on the top of each sensor.
Press the left arrow to exit Test Mode.